欢迎来到信誉一分彩网投大平台官方网站!
全国咨询热线0531-84277123
您的位置: 首页>> 产品中心 >>固定升降平台

山东固定升降平台

在生活中我们使用液压升降平台的时候,有时候总会出现一些小故障,今天就带大家认识一下液压升降平台故障排除方法。

在线咨询 服务热线15628816012

产品详情

在生活中我们使用液压升降平台的时候,有时候总会出现一些小故障,今天就带大家认识一下液压升降平台故障排除方法。
In our life, when we use hydraulic lifting platform, sometimes there will always be some minor faults. Today we will take you to know the troubleshooting methods of hydraulic lifting platform.
故障一:液压升降平台下滑。
Fault 1: Hydraulic lifting platform sliding.
产生的原因:常闭阀脏或单向阀脏、应急螺旋没有旋紧以及油路漏油或油缸内泄。
Causes: dirty closed valves or one-way valves, unscrewed emergency spirals and oil leakage or cylinder leakage.
排除的方法:可拆下常闭阀或单向阀清洗或更换、旋紧应急螺旋、检修油路及油缸。
Removal methods: removable normal closed valve or one-way valve cleaning or replacement, tightening emergency spiral, maintenance of oil pipeline and cylinder.
故障二:液压升降平台泵站不打油。
Fault 2: Hydraulic lifting platform pumping station does not oil.
产生的原因:
Reasons for this:
在电机电源不正常或反转时候、油箱无液压油或油量不够时、滤油器堵塞严重时、常闭阀脏或者常闭阀与电机同时通电时、调节阀设定压力不足或者齿轮泵设定电压不足时、液压油老化变质、应急螺旋没有旋紧、吸油管与齿轮泵处链接松动、漏气时。
When the power supply of the motor is abnormal or reversed, when there is no hydraulic oil or insufficient oil in the tank, when the oil filter is blocked seriously, when the normal closing valve is dirty or the normal closing valve is energized with the motor at the same time, when the setting pressure of the regulating valve is insufficient or the setting voltage of the gear pump is insufficient, the hydraulic oil deteriorates, the emergency screw is not tightened, the suction pipe and the gear are not tightened. When the link at the pump is loose and leaks air.
排除的方法:
Exclusive methods:
真确连通电机电源或调整转向、添加液压油、清洗滤油器或更换液压油、拆下常闭阀用清洗剂或煤油清洗、正确接线,电机通电时常闭阀断电、调整压力阀、更换齿轮泵、更换液压油、旋紧应急阀、紧回吸油管。
Really connect the motor power supply or adjust the steering, add hydraulic oil, clean oil filter or replace hydraulic oil, remove the cleaning agent or kerosene for the normal closed valve, clean and correct wiring. When the motor is electrified, the valve is often closed, the pressure valve is adjusted, the gear pump is replaced, the hydraulic oil is replaced, the emergency valve is tightened, and the back suction pipe is tightened.
故障三:液压升降平台泵站不回油。
Fault 3: The pump station of hydraulic lifting platform does not return oil.
产生的原因:常闭阀电源没接通或电压不足或者常闭阀线圈电压与电压类型与电源电压及电压类型不符、常闭阀线圈烧损或者背冒松落时、下降调速阀关死、常闭阀卡死。推荐:液压升降平台厂家广州欧力特机械设备有限公司
Reasons: the normal closed valve power supply is not connected or the voltage is insufficient or the voltage type and voltage type of the normal closed valve coil are not consistent with the voltage and voltage type of the power supply, when the normal closed valve coil is burned or the back is loosened, the descending speed regulating valve is closed, and the normal closed valve is stuck.  Recommendation: Guangzhou Olite Machinery Equipment Co., Ltd., a manufacturer of hydraulic lifting platform
排除的方法:
Exclusive methods:
正确接线并检查电压、检查电压及电压类型使电源提供的电压类型与常闭阀线圈所需的电压类型一致、更换常闭阀线圈、紧固常闭阀背冒、打开下降调速法或者拆下常闭阀清洗
Connect correctly and check the voltage, check the voltage and voltage type to make the voltage type supplied by the power supply consistent with the voltage type required by the normal closed valve coil, replace the normal closed valve coil, tighten the back of the normal closed valve, open the down speed regulation method or remove the normal closed valve for cleaning.

信誉一分彩网投大平台大型济南液压升降机厂家,青岛电动升降平台厂家,淄博液压升降平台厂家,枣庄液压升降机厂家,东营液压升降平台厂家,烟台液压升降机厂家,潍坊液压升降平台厂家,济宁液压升降平台厂家,泰安电动升降机厂家,威海液压升降平台厂家,日照电动升降机厂家,滨州液压升降平台厂家,德州电动升降机厂家,聊城液压升降平台厂家,临沂液压升降机厂家,菏泽液压升降平台厂家,莱芜液压升降机厂家,临沂电动升降机厂家需要的朋友欢迎采购0531-84277123 文章来源:

热品推荐
XML 地图 | Sitemap 地图